Ur Board And Wi-Fi Module Removal - Sony NSZ-GS7 Service Manual

SECTION 2 - DISASSEMBLY/PART NUMBER INFORMATION

UR BOARD AND WI-FI MODULE REMOVAL

A Remove 2 screws and lift up UR Board to detach from MS Board
SCREW M2.0 x L5 (Qty.2)
B Remove 2 screws and 3 antenna connectors, then lift up Wi-Fi Module to detach from MS Board
C Remove the Wi-Fi cables from the MS Board and the G Board Assembly (Switch Regulator) clips
CAUTION: DO NOT pull on the antenna cables at the solder joint when removing them from the clips.
Refer to "Wire Dressing" on page 17
SCREW M2.0 x L2.5-J (Qty. 2)
NSZ-GS7/NSZ-GX70
when reinserting the antenna cables back into the clips.
NOTE: The label on the Wi-Fi Board may cover the screw locator illustration on the board.
Screw Locator
is covered by label
13