NWZ-S754/S755
2-5.
OPEN THE SHORT-LAND
Note 1: This illustration sees the mechanical commonness block from LCD assy side (lower half).
Note 2: Make sure to remove one solder to become an open state before disassembling the mechanical commonness block.
Note 3: Solder the short-land after all wirings are connected when you exchanged some mounted board.
2-6.
EMMC BOARD
Note 1: The EMMC board cannot exchange with single. When exchanging the EMMC board, exchange it at the same time as the MOTHER board.
2 connector
12
1 Remove the solder of short-land (SL9501).
1 cushion (NAND)
Note 2: Lift vertically the EMMC board
when you remove the connector.
– Rear side view (bottom side) –
4 EMMC board
3