Tft Board-2 - Sony XAV-AX210 Service Manual

XAV-AX210

3-12. TFT BOARD-2

Note 1: Replaced old TFT board is destroyed
with the hammer, and throw out it.
5 Unlock the connector.
(CON8)
terminal side
8 screw
(PTT2.6
6 Draw the FFC
(35 pin) out of
the connector.
hole
4 Draw the FFC (20 pin)
out of the connector.
rear side
terminal
2 Draw the FFC
side
(60 pin) out of
the connector.
21
Note 2: When the TFT board is replaced, be sure to refer the following, and perform them.
• COMMUNICATION CHECK OF Apple CarPlay OR Android Auto (page 9)
• FLICKER ADJUSTMENT (page 23)
top side
5)
hole
rib
1 Unlock the
connector.
(CON7)
0 TFT board
(See Note 1, 2)
Note 3: When installing the TFT board,
align the two ribs and two holes.
rib
front side
9 Draw the BT antenna
cable out of the groove.
7 screw
(B2 8)
groove
How to install the flexible flat cable
Insert the flexible flat cable straight into the interior.
7 screw
There is a possibility that using this unit without
(B2 8)
the flexible flat cable correctly installed will damage it.
OK
Insert straight into
the interior.
connector
flexible flat cable
Sony CONFIDENTIAL
For Authorized Servicer
3 Unlock the connector.
(CON5)
terminal side
NG
Insert only part way. Insert at a slant.
connector connector
flexible flat cable flexible flat cable
NG
SYS SET