Tft Board-1 - Sony XAV-AX210 Service Manual

XAV-AX210

3-11. TFT BOARD-1

• Continued on 3-12 (page 21).
– Rear view –
– Rear view –
filament tape
(sub material)
(L = 30 mm)
20
top side
top side
TFT
board
filament tape
(sub material)
(L = 50 mm)
7 filament tape
(sub material)
top side
TFT
board
3 filament tape
(sub material)
rear side
8 Unlock the connector.
(CON2)
4 Unlock the
terminal
side
terminal
side
9 Draw the TFT FPC
out of the connector.
5 Draw the touch panel FPC
out of the connector.
Note about installing the BT antenna cable connector
When installing the BT antenna cable connector,
insert vertically, and push it from the top.
Insert vertically.
BT antenna cable
6 Peel off the
protect sheet.
connector
front side
1 filament tape
(sub material)
How to install the flexible flat cable
Insert the flexible flat cable straight into the interior.
connector. There is a possibility that using this unit without
(CON4) the flexible flat cable correctly installed will damage it.
OK
Insert straight into
the interior.
connector
flexible flat cable
Sony CONFIDENTIAL
For Authorized Servicer
OK NG
Insert at a slant.
BT antenna cable
connector
front panel block
2 BT antenna cable
connector (CON9)
filament tape (sub material)
(L = 20 mm)
CON9
screw
Pass the BT antenna
cable beside the screw.
NG
Insert only part way. Insert at a slant.
connector connector
flexible flat cable flexible flat cable
top side
TFT
board
groove
NG
SYS SET