Led Board - Sony ZS-BTY50 Service Manual

2-36. LED BOARD

Wi e setting
LED board
cushion
(RED MODEL)
heet (PWB LCD) setting
sheet (PWB LCD)
guide line
LED board
Note 2: Check that the outside of
LED board is hidden.
loudspeaker (10.2 cm) (Lch)
(SP1)
cushion
5 Remove the LED board
in the direction of an arrow.
7 LED board
4 two tapping screws
(BV B2.6)
3 two sheets
(PWB LCD)
NG
Note 3: Sheet (PWB LCD) must
not cover screw hole.
guide line
The knot at a tip is outside.
– B tt si e ie
(RED MODEL)
Note 4: When installing the LED board, check
6 connector
(CN602)
2 tape
1 Cut the binding band (taiton).
Note 1: In reassembling, use new binding
band (taiton) to fasten the clamp
same as before.
Wi e setting
Note 5: Check the position of
the binding band (taiton).
OK
The knot at a tip is inside.
– B tt si e ie –
NG
Wire is outside.
– – B tt si e ie –
ZS-BTY50/BTY52/BTY55
that sheet (light interception) is outside.
LED board
– Re si e ie
(sub material)
tape (sub material)
binding band (taiton)
150 ± 5 mm
–
31