jablotron CL-301SL Quick Start Manual

Pneumatic central locking system:
Simplified additional installation of central locking system:
whole system from the driver's door is not requested, you can use the following easy solution. Install two-
wires actuator (recommended type CM-2) to each door of your car. Connect them as shown in the
following diagram. Program duration of CL-301SL output pulses 0.3 seconds. This way all actuators are
operated with the remote control.
Note: Dispose of batteries safely depending
on the type of the batteries and local
regulation. Although this product does not
contain any harmful materials we suggest you
to return the product to the dealer or directly to
the producer after usage
Remote control for central locking CL-301SL
Program duration of output pulses 4 seconds.
When manual operation of the
Pod Skalkou 33
466 01 Jablonec nad Nisou
Czech Republic
Tel.: +420 483 559 999
fax: +420 438 559 993
Internet: www.jablotron.cz
4/4
REMOTE CONTROL FOR CENTRAL LOCKING CL-301SL
Description:
The CL-301SL can be connected to various kinds of central locking systems. It also provides
a separate signal to release a trunk (or a 5th door). The CL-301SL offers an economical solution for remote
control, especially for cars equipped with an immobilizer from the manufacturer.
The receiver unit is controlled by a remote RF control. Communication is protected by a special "HOPPING"
digital code that is changed after each transmission. Additional protection is offered by an ANTI-SCAN
feature. This type of system provides a much higher safety level than other systems using only a fix code.
An optional re-lock function checks if the car was entered within 1 minute after unlocking. If not, it will lock
automatically again. This prevents the car from being accidentally unlocked and left unprotected. Protection of
accidental locking while driving is also an optional function of this device.
There are two remote controls in each CL-301SL set. The device can be operated with a maximum of three
remote controls. A new remote control can be added to the CL-301SL when necessary (in learning mode of the
receiver unit). The CL-301SL is preset by the manufacturer to interface with an electromechanical central
locking system which requests negative control signals. However, optional signal settings can be easily set.
Specifications:
operating voltage
stand by consumption
built-in fuse
working distance
working frequency
coding system
built in transmitter type
built in receiver type
output signals
turn indicators outputs
trunk (5. door) release output
Can be operated according to ERC REC 70-03
Hereby, Jablotron Ltd., declares that this CL-301SL is in compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC. Original of the conformity assessment can be found at the web page
www.jablotron.cz, section Technical support.
Control unit
unlock
of central
lock
locking
Control unit
of powered
windows
lock
"15"
DOOR
SWITCHES
IGNITION
KEY
MCK51104 Remote control for central locking CL-301SL
10 - 16VDC
8mA
15A
up to 20m
433.92MHz
digital floating code, max. 3 remote control
TX-9
REC-5
negative pulses (GND), max. 200mA, programmable duration
(0.3 - 4 - 60 sec.). Manufacture initial setting 2 sec.
2 x +12V/5A
pulse +12V/15A, duration 0.5 sec.
antenna
Max 3
remote controls
1 9
TURN LIGHTS
trunk (5. door)
OUTPUTS
release actuator
supply +12V
Fuse 15A
GND
1/4 MCK51104