ABB AWT420 Manual page 14

14 AW T4 2 0 U N I V E R S A L 4 - W I R E , D U A L- I N P U T T R A N S M I T T E R | C O M/A W T4 2 0/ E T H E R N E T- E N R E V. C
...5 Configuration
...FTP connections
...Installing FileZilla
Finally, select the tab Transfer Settings, set the values Transfer
mode as Passive and check Limit number of simultaneous
connections. Set Maximum number of connections to 1.
Figure 23 FileZilla Connections dialog part 3
When all the parameters are set, press the Connect button to
connect to the device.
The following dialog is displayed:
Figure 24 FileZilla Enter password
Once the password is typed in the dialog, the connection is
established, either securely or not, depending on the device
setup.
When connecting securely, a dialog asking if the device
certificate is to be trusted is displayed. Ensure the device
identifier corresponds to the one created in the device during
the First Provisioning procedure shown on page 10.
An example of this dialog is shown below:
Figure 25 Unknown Certificate prompt
This step is not necessary if the connection is done with plain
FTP, without the ex-change of digital certificates.
Finally, when pressing OK, the following window is shown.
Notice that on the right-hand side it is possible to see the data
stored in the device, while on the left-hand side, the local
computer folders structure is shown. When question marks are
shown in the folder name, it means that the folder has not been
read yet, so the content is unknown.
Figure 26 FileZilla connected to the remote instrument