Use And Operation; Repair & Maintenance; Installing Casters Or Legs; Placing The Cabinet - Perlick BC Series Installation And Operation Instructions Manual

FLAT TOP BOTTLE COOLERS
Operation/Installation Manual

Use and Operation

USE & OPERATION
Do not use or store flammable
DANGER
liquids (ie; gasoline) or vapors near
the appliance to avoid fire.
If service is necessary, repair work
CAUTION
should be performed by a Perlick-
authorized service personnel. Work done by unqualified
individuals could create dangerous conditions in unit
that may result in serious injury or death.
The unit must NOT be totally
NOTICE
enclosed or damage may occur.
REPAIR & MAINTENANCE
All service work shall be performed
WARNING
by Perlick-authorized service
personnel. All component parts shall be replaced with
like components. Incorrect parts or improper service
may result in fire.
INSTALLING CASTERS OR LEGS (OPTIONAL)
Attach bracket assembly to the bottom of the cabinet base
using the ¼"-20 Philips head machine screws provided.
Attach casters or legs to the mounting bracket with ¼" – 20
Philips head screws provided
To comply with NSF requirements,
NOTICE
cabinet must be sealed to floor or
on legs, casters, or rollers.
ADJUSTABLE PARTITIONS & SHELVING
Perlick Bottle Coolers may be provided with adjustable
partitions and shelving which will accommodate various
bottle sizes.
• Remove bottles and cans from their cases before
placing in cooler to ensure proper air flow.
• When loading product into cabinet, care must be
taken to avoid blocking airflow into and out of the
evaporator. Maintain at least 2" of clearance on
evaporator air intake and exhaust for proper
operation.
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice

PLACING THE CABINET

To assure maximum performance, fresh air must
be allowed to circulate through the machinery
compartment. It is important to allow at least two inched
of clearance at the back or left end of the cabinet. Do
not place anything in front of the cabinet that would
obstruct air flow at these grilles. Do not place the unit in
an unventilated small room.
Removing the factory installed
CAUTION
back clearance spacers without
providing proper left side grill clearance for
compressor air flow will void the warranty.
Cabinet should be leveled.
For sanitation purposes, it may be necessary to seal the
base of the cabinet to the floor. This can be accomplished
by laying a bead of silicone sealant along the base of the
cabinet as shown by the figure below (figure 1).
Cabinet
Bead Silicon
Sealer (RTV)
Floor
Figure 1. Sealing Cabinet to Floor
6