Other Notes - Furuno TZT2BB Instructions Manual

7. Other Notes

(1) With dual monitors connected to the HDMI OUT 1 (primary) and HDMI OUT 2 (secondary), the following settings are
accessible on the primary (HDMI OUT 1) monitor only.
[Settings] – [Initial Setup] – [Chart Master] – [ON]/[OFF]:
Chart Master can be turnd on/off at the primary monitor only.
[Settings] – [General] – [Wireless LAN Settings]:
Set the Wireless LAN menu such as entering SSID to an access point at the primary monitor.
(2) With dual monitors connected to the TZT2BB processor unit, only one SD card for chart is fine to show charts on both
monitors. You do NOT need to insert two (2) chart cards.
(3) The NavNet Remote, Viewer, Controller apps are planned to be updated to be compatible with TZT2BB network.
(4) The brilliance of external monitors are adjusted at the monitor side.
8. Software Versions - TZTL12F/15F and TZT2BB
The TZT2BB is installed with the software version 5.1x at the factory. This version is installed on the TZT2BB only, not
on the TZTL12F/15F. The next software version 6.01 will be in common with all the TZTL12F, TZTL15F, and TZT2BB.
- Android™ is registered trademarks or trademarks of Google Inc.
- All brand and product names are registered trademarks, trademarks or service marks of their respective holders.
Models Versions
TZTL12F/15F v5.03
TZT2BB v5.1x
--- END ---
Future Version
Common versions
28