Hamilton HTK Programming Manual page 94

verification code to enter in order to access the HTK. Leaving this "OFF" will allow you to remote directly
into the HTK within its own network. If changes are made, click save and activate changes
Note: The 2 factor authentication will still be required outside the local network.
No Prox. w/Screen Saver: If turned "ON", all the buttons on the HTK will flash while the screensaver
video plays and the customer must hit a button to change the HTK to the wash menu screen. If you
leave this "OFF" once the proximity sensor is covered, the HTK will automatically change back to the
wash menu screen.
Hide indicators: There are two black dots in the bottom middle of the display pay screen. These
indicators are so you can see the cycle signal change of state without having to open the HTK. If the
black dot on the right side turns white that means the HTK is receiving the cycle signal from the
equipment it is wired to. If you turn "ON" hide indicators, means the two dots will not be visible on the
screen.
Click save click activate changes to save the settings. Then click the back button to the previous page.
Continue to click Back until you are at the page you need.
Document #101-0243 94 02/01/18