Hamilton HTK Programming Manual page 41

Message 1: This is what will display to the customer when they pull up to the HTK. If you would like to
change this from the current default message, turn OFF "Use Default" and then click in the text field and
type the message you wish to be displayed.
Enabled – this will turn the audio ON / OFF
Message 1 Audio: This is what the HTK will speak to the customer when they pull up. To enable this, you
must turn ON enabled button.
This will be set at the factory to match the text prompt. If you turn OFF the "use default" from the above
text prompts, you can then choose from the pull down menu. Or if you have custom voice prompts, click
on the browse button. You can then browse your computer to find your custom prompts.
*NOTE: The browse button can only be seen when you remote into the HTK
Message 1 Video: Is a video that the HTK will play for the customer. This can be added with customer
video files. Hamilton Manufacturing does not supply these videos. Videos should be a .wmv or .mp4 file,
(320x240) and less than 20MB. They can be played on the following screens.
• Welcome Prompts • Screen Saver • CAR WASH BUSY PLEASE WAIT message. (For waiting when not
gated... No Stacking or Gate Controlled cycle signal mode)
• CAR WASH WAIT FOR GATE (for waiting when No Stacking or Gate Controlled) • Buy Up Items (Cycles
through videos while waiting for buy up choices)
*NOTE: Contact Hamilton Manufacturing before using video to be sure it is compatible.
If you would like to have more than one welcome prompt, repeat these steps for messages 2 and 3.
Document #101-0243 41 02/01/18