Table of Contents
Advertisement
7.0 Display Self-Test
1.
Power-off the system unit and display.
2.
Disconnect the display signal cable.
3.
Power-on the display.
4.
Turn the contrast to its maximum position.
5.
Turn the brightness control to the center detent position.
The screen should be white with a black margin, as described below (some
shading may occur near the edges).
display.
If the display passes the test, replace the system board or
display adapter that the display is attached to.
8503, 8512, 8513, 8514:
sides.
8506:
2-35 mm (0.08-1.38 in.) wide on the top, or bottom, or both.
8507, 8508:
2-20 mm (0.08-0.79 in.) wide on the top, or bottom, or
both.
Printed in the United States of America
HMR Diagnostics for Non Micro Channel
Display Self-Test
If the screen differs, replace the
2-20 mm (0.08-0.79 in.) wide on one or both
¦ Copyright IBM Corp. 1990
7.0 - 1
Advertisement
Table of Contents
