Installation; Power Requirements - Qsonica MICROSON XL 2000 Operator's Manual

WARNING!
High voltage is present in the generator, convertor and high frequency cable. Do not attempt
to remove the generator cover or convertor case.
Do Not touch any open cable connections on the unit while the power is turned on.
A.

Power Requirements

The generator requires a single phase, grounded, three-wire, 115V or 220V, 50/60 Hz source,
unless otherwise fitted, and has a 3 amp fuse for 115V service or a 1.5 amp fuse for 220V
service. There is a select switch on the rear panel of the generator to set voltage for 115V (92
140RMS) or 220V (200
CAUTION: Do not operate a unit set for 115V service on 220V line or operate a unit set for
220V service on a 115V line.
WARNING: The electrical line cord is equipped with a 3-prong grounding plug. Do not remove
the grounding prong under any circumstances. The plug must be plugged into a mating 3-prong
grounded outlet.
NOTE: Only use IEC approved fuses. Do not
amperage noted.
Cleaning Instructions
The generator and convertor may be cleaned using Windex
solution, and an anti-static cleaning cloth. Probes can be cleaned with isopropyl alcohol and
sterilized in an autoclave (probes only).
I N S T A L L A T I O N
240 VRMS) service.
or a similar acid-free cleaning
7