Advertisement
12
Part I: Wii Fit Plus
Figure 1-2:
The Balance
Board
with the
battery
cover
removed.
If you are upgrading from Wii Fit, Wii Fit Plus makes use of your previous
data. After the save data has been created, a confirmation screen
appears. Press A again. If you already have Wii Fit data, you are taken on
a brief tour of Wii Fit Plus's new features, and you can either skip ahead
to the "Incorporating the Wii Remote and Nunchuk" section of this
chapter, if you want a refresher on controller functionality, or go
straight to the "Navigating the Wii Fit Plus Menus" section. Otherwise,
you'll be prompted to sync the Balance Board to the Wii.
3. Remove the battery cover on the bottom of the Balance Board and
insert the four AA batteries if you have not done so already. Then
press the small red SYNC. button, as shown in Figure 1-2.
The blue power light on the Balance Board should now be flashing.
4. Open the SD Card slot cover on the front of the Wii console next to the
system disc slot. While the blue power light on the Balance Board is
still flashing, press the red SYNC. button on the Wii console, as shown
in Figure 1-3.
The power light on the Balance Board stops blinking and remains lit
after the synchronization is complete.
Advertisement
