Smartwares HA701IP Manual page 3

Welcome to the world of our Smart Home Wireless Alarmsystem HA701IP
We will guide you during the installationtrip; step by step! The trip will start with unpacking, sorting, screwing and
downloading, and will be accompanied by screenshots, so that you see what you get! We wish you a pleasant trip!
Step 1:
Unpack all the products and sort them on the table!
Step 2:
2.1 Write down the Access Code information of the back of the Gateway, on this field of the manual:
-
2.2 Open the battery compartment at the back side and install 6 x 1,5 V AA, close it again.
2.3 Plug in the internet (LAN) cable and the adaptor (POWER) in the contacts at the back.
2.4 Plug the other side of the internetcable in your router, and the adaptor in a powersocket.
Step 3:
Remove the insulating films on the back of the Motion Sensor and Magnetic Contact Sensor. Remove the insulating
films on the side of remote.
3
- - The Code is needed for system login.
2.1
2.3
2.2
2.4
2.2