GARDINER TECHNOLOGY GARDTEC 300 Series User Instructions page 7

GARDTEC 350
USER CODES
Users Manual
When programming User Codes you should note the following:-
a) User 1 is always the Master Code. This level of cod. e allows you to perform all
User functions (including resetting after an alarm) and all User Programming
functions. The Master Code may be changed by the Master User but it may
not be deleted.
b) User 2 is always a User level. This level of code will allow you to Set, Part
Set and Unset the system. If you wish to delete the code enter 0000 when
asked to enter the code during programming.
c) User 3 is a Set only level. This level will allow you to Set and Part Set the
system only. If you wish to delete this code enter 0000 when asked to enter
the code during programming.
To program the user codes proceed as follows:-
1)
2)
3)
With the Control panel in the DAY mode (Unset) enter the Master code. The
exit tone will sound.
Before the exit time expires Press NO. The exit tone will silence and the
!Plsmovs LED will flash.
Press NO Four times and the Program LED will flash as Fig 10.
Fig 10.
•ll:ll
POWER
CJ
DAY CJ
Page 10
GARDTEC 350
users iv1anua1
4)
5)
6)
7)
8)
Press YES to use the
!Pmgiram
(Codie) option. The display will show as
Fig 11
Fig 11.
POWER
CJ
Enter the User number you wish to program followed by YES from:-
1
=
Master Code
2 = User Code
3
=
Set Only Code
A comfort tone is generated if all is okay
Enter a new four digit code followed by YES (entering 0000 will delete the
present code , however the Master code may only be changed and not
deleted). A comfort tone will be generated if all is okay.
Enter the same four digit code again to confirm followed by YES. {If a mistake
has beenmade and no comfort tone is generated or if the two codes do not
match the code will not be updated.
If you wish to program other user codes repeat from step 4
To escape back to DAY mode press 0.
Note:
Any of the digits 0-9 may be used any number of times in a user code.
Page 11