Removing Individual Zones; Test; Log; Chims - GARDINER TECHNOLOGY GARDTEC 300 Series User Instructions

GARDTEC 350
The User programmable options are as follows:-
!Aemove
Users Manual
This option enables the Master user to Remove individual zones when setting the sys-
tem. This is in addition to any part set suites pre-programmed by your engineer.
Tesft
This option allows the Master user to Test the system.
log
This option allows the Master user to view the event Log.
C~ime
This option allows the Master user to turn the Chime option On and Off. (The zones
that are on chime will have been programmed by the installation engineer).
Program (Codie}
This option allows the Master user to change the Codes for the Master user (User1 ),
User (User2) and Set only user (User3) levels.
When programming the User options the LEDs may show the following status:-
Fig 3.
CJ
OFF
•ON .
~ ~ FLASHING
To program the options shown above proceed as follows:-
Page
4
GARDTEC 350
Users Manual
REMOVING INDIVIDUAL ZONES
1)
2)
3)
With the Control panel in the DAY mode (Unset) enter the Master code. The
exit tone will sound.
Before the exit time expires Press NO. The exit tone will silence and the
Remove LED will flash as shown iri Fig 4.
Fig 4.
POWER □
•1:41
Press YES to program the
IRlemove
option. The display will sliow as Fig 5.
Fig 5.
POWER .CJ
DAY
CJ
Page 5