Testing The System - GARDINER TECHNOLOGY GARDTEC 300 Series User Instructions

GARDTEC 350
users Manua1
4)
5)
6)
Press the key corresponding to the zone you wish to remove followed by the
YES key (a comfort tone will be generated if all is okay). If you make a mis-
take and remove the wrong zone repeat the operation from step 3 but press
NO after the zone number.
If you wish to remove more zones repeat from step 3.
When you have finished removing the required zone(s) press the O key to
escape programming .mode. ·
Note: This operation should be carried out each time you wish to remove
individual zones. If you remove the same zone(s) on a regular basis ask
your engineer to put them in
a
part set suite.
Page 6
1
J
l
GARDTEC
350
TESTING THE SYSTEM
users Manua1
1)
2)
3)
With the Control panel in the DAY mode (Unset) enter the Master code. The
exit tone will sound.
Before the exit time expires Press NO. The exit tone will silence and the
IR!eimove LED will flash.
Press NO and the Tes1t LED will flash as shown in Fig 6.
Fig 6.
POWER CJ
DAY
CJ
4) Press YES to select the Tes1t option and the flashing Tes1t LED will illumi-
nate steadily.
5) You may now "walk test" the system. Any zones that are violated will
generate a tone and the appropriate LED will flash. If you wish to test the
external sounders and strobe pressing 9 will toggle the external sounders
and strobe On and Off.
6) To escape from the Test option press O and the display will show as in Fig 6.
7) If you wish to return to DAY mode Press O again.
Page 7