ProGear Hendrickson HN FR Series Service Manual page 38

NOTE
17730-285
Pro Gear and Transmission • 906 W. Gore St. Orlando, FL 32805 • 1 (877) 776-4600 / (407) 872-1901 • parts@eprogear.com
FIGURE 8-22
The end bushing must be square with the equalizing beam end hub before pressing the end
bushing into the equalizing beam. End bushings pressed in at an angle will damage the end
bushing and the equalizing beam.
5. Verify the end bushing's outer metal is square with the end hub. Equalizing beam and end
bushing damage will result if the bushings are pressed in at an angle.
CARE MUST BE TAKEN DURING THE INSTALLATION OF THE BUSHING. DO NOT PUSH ON THE INNER
METAL OF THE BUSHING, DOING SO WILL CAUSE DAMAGE TO THE BUSHING AND VOID WARRANTY.
6. Install the end bushing into the end hub
by pressing on the installation tool until
the installation tool contacts the end
hub. This will center the bushing in the
end hub, see Figure 8-23.
7. Install the equalizing beam assembly
into vehicle as detailed in equalizing beam assembly in this section.
FIGURE 8-23
37
HN ® FR Series
Component Replacement