Rebound Strap - ProGear Hendrickson HN FR Series Service Manual

Table of Contents

Advertisement

HN
®
FR Series
FIGURE 8-4

REBOUND STRAP

DISASSEMBLY
SERVICE HINT
Vehicle may need to be in the loaded condition for the rebound strap to be slack enough for
removal.
1. Chock the front wheels.
2. From the inboard side of the saddle remove the ½" locknuts
3. From the outboard side remove the ½" locknuts and ½"
SERVICE HINT
The anchor plate assembly welds of bolt heads DO NOT need to be cut or separated to replace
rebound strap.
ASSEMBLY
1. Install the upper anchor plate through the rebound strap
2. Attach the upper anchor plate to the auxiliary spring mounting plate. Tighten the fasteners
3. Install the lower anchor plate through the rebound strap.
4. Attach the lower anchor plate to the equalizing beam. Tighten the fasteners to
5. Remove the wheel chocks.
Component Replacement
Pro Gear and Transmission • 906 W. Gore St. Orlando, FL 32805 • 1 (877) 776-4600 / (407) 872-1901 • parts@eprogear.com
and ½" flat washers from the top of the upper anchor plate
assembly of the rebound strap.
flat washers from the lower anchor plate assembly of the
rebound strap. This will free the rebound strap and anchor
plate assembly. Slide off, and free both ends of rebound
strap from the anchor plate assembly, see Figure 8-5.
to
90-105 foot pounds torque.
foot pounds torque.
26
FIGURE 8-5
90-105
17730-285

Advertisement

Table of Contents
loading

Table of Contents