Bar Pin End Bushings - ProGear Hendrickson HN FR Series Service Manual

HN ® FR Series
FIGURE 8-17
Tightening Torque 220-300 ft. lbs.
28. Install the lower anchor plate assembly through the rebound strap and attach it to the
29. Remove the wheel chocks
FIGURE 8-18

BAR PIN END BUSHINGS

NOTE Hendrickson bar pin service kits containing alignment shims, (Kit No. 34013-088L) or (Rotating
Bar Pin Bushing Kit No. 34013-188) contain all the components required for one equalizing
beam end, s ee Parts List Section of this publication.
YOU WILL NEED:
■
■
■
Component Replacement
Pro Gear and Transmission • 906 W. Gore St. Orlando, FL 32805 • 1 (877) 776-4600 / (407) 872-1901 • parts@eprogear.com
Equalizing Beam Aligning Pins
¾" Vee Bracket Locknut
equalizing beam, see Figure 8-18. Tighten the fasteners to
A shop press with a capacity of at least 100 tons
Bar pin adapter set tool – Refer to Special Tools Section of this publication for the tools to
remove and install the bar pin style rubber end bushings
Receiving tool – The receiving tool is a shop made tool which completely supports the
beam hub being serviced and is tall enough to receive the bushing as it is being pressed in
or out, see Special Tools Section of this publication
34
Bolster Spring with
Vee Bracket Assembly
¾" Hex Head Bolt
Equalizing Beam
90-105 foot pounds torque.
17730-285