Maintenance - LIFAN Power USA PRO Series Operating Instructions And Owner's Manual

PROCEDURE
Engine OilCheck
Replace Engine Oil
Air Cleaner FilterCheck
Air Cleaner FilterReplacement
Air CleanerWash
Spark Plug
ValveClearance
Fuel Tank
NOTE: Refer to Following Procedures for Proper Method to PerformMaintenance
OIL CHANGE PROCEDURES:
engine oil should be performed after each 40 hoursof use of you Power Equipment Product. Check your engine
oil level prior to eachuse.
1. Start your engine and let it warm up to get the oil warm and thinner. Turn theengine On/OFF switch to
the "OFF" position. Turn Fuel Valve to the"OFF" position.
2. Remove the oil cap/dipstick by turning counter clockwise. Remove the oil drain plug located below the oil
cap/dipstick utilizing the appropriate tools.
USE CAUTION: THE OIL MAY BEHOT.
3. Drain the engine oil into an approved receptacle and discard in accordancewith all Federal and State
Regulations. Never dump the used engine oil on theground or into drains, only discard in an approved
manner. Check with your local authorities to determine the regulations in yourarea.

Maintenance

MAINTENANCESCHEDULE
TIME
EachUse
After Each 40 Hours of Use (For Initial Breakin – After
First (1st) 10 Hours ofUse
EachUse
When Needed or After Every 50 Hoursof Use
WhenNeeded
When necessary or within 100 hrs of run time
Check&Re--‐adjust annually or after300 Hours of Use
Replace Every 3 Years Based on Condition
Refer to Controls and Feature section fordiagram. Periodic Maintenance of your
39