Related Manuals for Dynaudio OW Series
Summary of Contents for Dynaudio OW Series
- Page 1 OW-6 User manual Table of Contents Start Warranty Introduction Positioning Connecting Mounting Backcover...
- Page 2 Dynaudio shall not be liable for damages to any other equipment or other items at the site of use, or any other damages whether incidental, consequential or otherwise. Dynaudio...
- Page 3 OW Series speakers are heavy and you must be sure that the structure and fittings chosen are able to support a minimum of 20 kg. If you have any concerns over the suitability of the structure, or doubt in your ability to fix the wall-mount brackets securely, you should seek professional advice and help.
-
Page 4: Carton Contents
Carton Contents Each OW Series speak pack contains the following items: 2 x OW Series speakers 2 x Connection cover panels 2 x Wall-mount brackets 8 x Connection cover panel screws 2 x Secondary restraint eyelets 1 x 5.5mm Allen key... -
Page 5: Speaker Positions
OW Series speakers are designed for both high performance and background sound applications either indoors or outdoors. If OW Series speakers are to be used for stereo or home theatre applications try to locate them as outlined in the following paragraphs:... - Page 6 Utility Audio Applications If OW Series speakers are to be employed as utility speakers to provide background music and/or public address announcements they should be mounted above head height and distributed throughout the space appropriately to provide the required level of coverage.
- Page 7 Connecting OW Series speakers are connected to speaker cables via screw terminal blocks located behind their connection panels. The connection panels, supplied separately within the shipping box, incorporate cable entry ducts with sealing glands that can be tightened to restrain the cable and prevent the ingress of moisture and dust. Each terminal blocks carries two pairs of positive and negative terminals.
- Page 8 Strip 5mm of insulation from the ends of the speaker cables and connect them to the appropriate terminals of the male connector body. Insert the male connector body into the female socket block. Re-tighten the retaining screws. Transfer the connection panel along the cable or cables until it is located in position on the rear of the speaker.
- Page 9 Before using your OW Series speakers ensure that the rear panel transformer selection switch is set appropriately. The transformer selection switch is illustrated in the following diagram. Use a coin or a flat bladed screwdriver to turn the switch. Inappropriate...
- Page 10 Note It is good practice to switch off the amplifier when changing transformer selection switch settings. When used with 70/100V line amplification the transformer selection switch must be set to one of the power setting positions. Higher power settings will result in increased speaker volume.
- Page 11 Mounting Adjustable mounting brackets are supplied with OW Series speakers. Use the brackets to mount the speakers at the required locations as described and illustrated in the following paragraphs and diagrams. Using the supplied 5.5 mm (7/32 in) Allen key fully loosen the clamp bolt and separate the ball and clamp components of the mounting brackets.
- Page 12 If you have any concerns over the suitability of the structure to which the brackets and speakers are to be attached, or doubt in your ability to fix the brackets securely, you should seek professional advice and help. Note The bracket mounting hardware and structure must be able to support at least 20kg. Screw the bracket ball component into the lower tapped hole on the rear panel of the speaker as far as it will go.
- Page 14 Outdoor series Designed and engineered in Denmark Made in China Dynaudio A/S 8660 Skanderborg Denmark dynaudio.com Outdoor series User manual © 2019 Dynaudio. Last edit: 2019-09-24...