Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Dynaudio Manuals
  4. Speaker System
  5. BM12 mkIII
  6. Owner's manual

Dynaudio BM12 mkIII Owner's Manual

Active monitor system
Hide thumbs

Advertisement

Quick Links

Download this manual
BM12 mkIII – Owner's manual

Advertisement

loading

Related Manuals for Dynaudio BM12 mkIII

Summary of Contents for Dynaudio BM12 mkIII

  • Page 1 BM12 mkIII – Owner’s manual...
  • Page 3 Introduction Introduction your outlet, consult an electrician for re- placement of the obsolete outlet. Important safety instructions 10. Protect the power cord from being walked on or pinched particularly at The lightning flash with an arrow- head symbol within an equilateral plugs, convenience receptacles, and triangle, is intended to alert the user the point where they exit from the ap-...
  • Page 4 Introduction – Be advised that different operating volt- EMC/EMI ages require the use of different types This equipment has been tested and found of line cord and attachment plugs. to comply with the limits for a Class B Dig- ital device, pursuant to part 15 of the FCC –...
  • Page 5 Introduction Owner’s manual...
  • Page 6 Introduction Introduction Break-in time Congratulations on your purchase of the The transducers of your Dynaudio Pro- Dynaudio Professional BM12 mkIII active fessional BM12 mkIII will achieve better sound quality after breaking in, especially monitor system. With the right care and at-...

  • Page 7: Operation

    Operation Operation Overview – rear panel Correct setup and connections is essential to achieve optimal performance from your monitors. Please follow the instructions on the following pages. 1. AC power Input and fuse 2. Power On/Off switch 3. Balanced analog input (XLR) 4. High Pass filter switch 5.
  • Page 8 Operation Setting up filter, thus allowing a higher undistorted 1/2. Power on/off switch / AC power in sound pressure level. Before switching on, make sure Mains 5. Level trim Voltage matches your areas Mains Voltage specification. Replace fuse only with the Use this switch to match the sensitivity of fuse-type marked on the rear-panel label.
  • Page 9 On the front you will find two diodes. These cur, and helps protect both the electronics and the loudspeaker drivers. are positioned just above the Dynaudio Lo- There is also a thermal sensor measuring 1. The green power diode indicates the temperature on the heat sink. An elec- speaker on/off status.

  • Page 10: Troubleshooting

    If you have replaced the fuse and there Service still is no sound, contact your Dynaudio There are no user serviceable parts inside Professional Dealer. the monitor. If service is required please contact service via: –...

  • Page 11: Technical Specifications

    Technical specifications Technical specifications System Two-way Active Near-field Monitor Frequency Response (+/- 3 dB) 38 Hz to 21 kHz Input level for 85 dB SPL @ 1 m -18 dBu RMS @ 0 dB setting Input Impedance 65 kOhm each branch Power consumption Idle: 15 W / Max: 130 W Amplifier power Tweeter: 50 W / Woofer: 100 W Max SPL 1m, pair (IEC Short Term)
  • Page 12 Notes Notes BM12 mkIII...
  • Page 13 Notes Owner’s manual...
  • Page 14 Notes BM12 mkIII...
  • Page 15 Notes Owner’s manual...
  • Page 16 © Dynaudio A/S, 8660 Skanderborg, Denmark Owner’s Manual BM12 mkIII 0214 – item no. 455437 All text and image copyrights reserved. Subject to change without notice. www.dynaudioprofessional.com...