Advertisement
Quick Links
Advertisement
Related Manuals for Dynaudio BM6 mkIII
Summary of Contents for Dynaudio BM6 mkIII
- Page 1 BM6 mkIII – Owner’s manual...
- Page 3 Introduction Introduction your outlet, consult an electrician for re- placement of the obsolete outlet. Important safety instructions 10. Protect the power cord from being The lightning flash with an arrow- walked on or pinched particularly at plugs, convenience receptacles, and head symbol within an equilateral triangle, is intended to alert the user the point where they exit from the ap-...
- Page 4 Introduction EMC/EMI – Be advised that different operating volt- ages require the use of different types This equipment has been tested and found of line cord and attachment plugs. to comply with the limits for a Class B Dig- – Always observe the local safety regula- ital device, pursuant to part 15 of the FCC rules.
- Page 5 Introduction Owner’s manual...
- Page 6 Introduction Introduction Break-in time Congratulations on your purchase of the The transducers of your Dynaudio Pro- Dynaudio Professional BM6 mkIII active fessional BM6 mkIII will achieve better monitor system. With the right care and at- sound quality after breaking in, especially...
-
Page 7: Operation
Operation Operation Overview – rear panel Correct setup and connections is essential to achieve optimal performance from your monitors. Please follow the instructions on the following pages. 1. AC power Input and fuse 2. Power On/Off switch 3. Balanced analog input (XLR) 4. High Pass filter switch 5. - Page 8 Operation filter, thus allowing a higher undistorted Setting up 1/2. Power on/off switch / AC power in sound pressure level. Before switching on, make sure Mains 5. Level trim Voltage matches your areas Mains Voltage Use this switch to match the sensitivity of specification. Replace fuse only with the fuse-type marked on the rear-panel label.
- Page 9 On the front you will find two diodes. These cur, and helps protect both the electronics and the loudspeaker drivers. are positioned just above the Dynaudio Lo- There is also a thermal sensor measuring 1. The green power diode indicates the temperature on the heat sink. An elec- speaker on/off status.
-
Page 10: Troubleshooting
If you have replaced the fuse and there There are no user serviceable parts inside still is no sound, contact your Dynaudio the monitor. If service is required please contact service via: Professional Dealer. -
Page 11: Technical Specifications
Technical specifications Technical specifications System Two-way Active Near-field Monitor Frequency Response (+/- 3 dB) 40 Hz to 21 kHz Input level for 85 dB SPL @ 1 m -14 dBu RMS @ 0 dB setting Input Impedance 65 kOhm each branch Power consumption Idle: 15 W / Max: 130 W Amplifier power Tweeter: 50 W / Woofer: 100 W Max SPL 1m, pair... - Page 12 Notes Notes BM6 mkIII...
- Page 13 Notes Owner’s manual...
- Page 14 Notes BM6 mkIII...
- Page 15 Notes Owner’s manual...
- Page 16 © Dynaudio A/S, 8660 Skanderborg, Denmark Owner’s Manual BM6 mkIII 0214 – item no. 455431 All text and image copyrights reserved. Subject to change without notice. www.dynaudioprofessional.com...