Real Flame Helios 202 Instructions Manual page 4

1. Make sure the valve knob is turned all the way clockwise to the CLOSE position.
As shown in figure 1
2. Place the plated steel washer ( 210 ) on the umbrella hole on the table top as shown
in below figure 2, and then place the firepit base on the center of the umbrella base
hole, and have the gas tube of the regulator go through the plated steel washer and
umbrella hole
3. Place another plated steel washer ( 210 ) at the gas tube of the regulator as shown
in Figure 3
4. Screw the 'Butterfly' nut ( 211 ) into the gas tube of the regulator, and tighten it
as shown in Figure 4
ASSEMBLY
Figure 1
Figure 2
Figure 3
Figure 4
5