Mitsubishi Electric MR-JET- G Series User Manual page 74

[AL. 09E.A_Communication cycle setting warning]
Cause
1.
Servo parameter settings primarily for the
control mode and functions that are not
supported by the network communication
cycle currently in use have been selected.
2.
The values of the servo parameters for
manufacturer setting were changed.
1 SERVO AMPLIFIER TROUBLESHOOTING
72
1.3 Handling methods for alarms/warnings
Check/action method
Check the servo parameters and change the communication cycle to one that
is compatible with the set control mode and functions.
For the function restrictions of the network communication cycle, refer to
"Function restrictions" in the User's Manual (Introduction).
Restore the values of the servo parameters for manufacturer setting to the
initial values.
Model
[JET-G]