Table of Contents
Advertisement
4 Installation and maintenance
Installation precautions
Mount Smile 41 AS-i using two M5 bolts before attaching the M12-connector. Tightening torque: 2 Nm.
Warning! All the safety functions must be tested before starting up the system.
Assembly of colored filters
To illustrate the different functions of the push-buttons, colored filters can be pressed over the original push-
buttons as shown below. A kit with five filters in different colors are delivered with the unit.
Maintenance
Warning! The safety functions and the mechanics shall be tested regularly, at least once every year to confirm that
all the safety functions are working properly.
Warning! In case of breakdown or damage to the product, contact the nearest ABB Jokab Safety Service Office or
reseller. Do not try to repair the product yourself since it may accidentally cause permanent damage to the product,
impairing the safety of the device which in turn could lead to serious injury to personnel.
Caution! ABB Jokab Safety will not accept responsibility for failure of the switch functions if the installation and
maintenance requirements shown in this sheet are not implemented. These requirements form part of the product
warranty.
2TLC172255M0201, rev. D
Smile 41 AS-i is supplied with 30 VDC from the AS-i bus.
Recommended connection to the AS-i bus is through a flat
cable connector to M12 (see figure to the left), making it
possible to quickly and easily connect the unit to the yellow
AS-i cable.
Smile 41 AS-i can also be connected directly to the AS-i bus
using only two cables (pin-1 and 3 of the M12-connector on
the unit).
8
www.abb.com/jokabsafety
Hide quick links:
Advertisement
Table of Contents
