Kenwood TK-3401D Service Manual page 17

3.2.4 Mounting the Chassis to the Case Assembly
(1) Confirm that the waterproof packing attached to the cir-
cumference of the chassis is securely inserted in the
groove of the chassis <1>.
(2) Insert the upper part of the chassis into the case assembly
<2>.
(3) Press the chassis <3> and the case assembly together to
attach them.
Caution:
If the packing of the SP/MIC is not at the correct position
after attaching the chassis to the case assembly, reposi-
tion the packing with your fingers.
<3>
<3>
<1>
<2> <2>
3.2.5 The Nuts of the Volume Knob and Channel Knob
Note that the shape, color and height of the nuts of the volume
knob and channel knob are different from one another. (The nut
of volume knob is silver, and the nut of channel knob is gold.)
Use the following jig when removing the nuts of the volume knob
and channel knob:
• Jig (Part No.: W05-1012-00)
for Volume knob
(Long)
3.2.6 Screw sequence for mouting the TX-RX unit to the
chassis
Attach the TX-RX unit to the chassis using the screws in order
shown in drawing below.
11
9
7
5
4
2
for Selector knob
(Short)
12
10
8
6
3
1
(No.RA012<Rev.001>)1-17