Power Supply; Overview; Rear View - Philips PicoPix Micro User Manual

Power supply

Use only a certified power adapter. Check
whether the mains voltage of the power supply
matches the mains voltage available at the
setup location. This product complies with the
voltage type specified on the product.
The power outlet shall be installed near the
product and shall be easily accessible.
The capacity of the built-in battery diminishes
with time. If the product functions only with
external power supply, the built-in battery is
defective. Contact an authorised service centre
to replace the built-in battery.
CAUTION!
Always use the
projector off.
Turn off the product and unplug from the
power outlet before cleaning the surface
(see Cleaning, page 11). Use a soft, lint-
free cloth. Never use liquid, gaseous or easily
flammable cleaners (sprays, abrasives, polishes,
alcohol). Do not allow any moisture to reach
the interior of the product.
DANGER!
Risk of eye irritation!
This product is equipped with a high
power LED (Light Emitting Diode),
which emits very bright light. Do not
look directly into the projector lens
during operation. This could cause eye
irritation or damage.

Overview

button to turn the
2 Overview

Rear view

a b c
USB
h
Reset key
a
Reset the projector to the factory default
settings (use a small pin to press the reset
key).
IR sensor
b
Micro USB port
c
Connect to the power supply.
d
3.5 mm audio output; connect to external
speakers or headphones.
Mini HDMI port
e
Connect to the HDMI output on a playback
device.
f
• Press and hold three seconds to switch
the projector on or off.
• Access the settings menu.
• Confirm a selection or entry.
• When the projector is switched on, the
LED turns blue. When the projector is
switched off, the LED turns off.
• When charging the projector, the LED
turns red regardless of the projector
switching on or off.
/
g
• Navigate menu options.
• Increase or decrease volume.
h
Return to a previous menu screen.
d e
HDMI
g f
5