These dam- ages can result from improper handling. Danger to Persons! DANGER! Danger to Persons! This symbol gives warning of danger to per- sons. Physical injury or damage can result from improper handling. Philips · PPX1230...
Table of Contents Overview ... 2 Dear Customer ... 2 Packing Contents ... 2 About this User Manual ... 2 1 General Safety Information ... 4 Setting Up the Device ... 4 Repairs ... 4 Power Supply ... 4 2 Overview... 5 Top of the Device ...
If the device overheats or emits smoke (switch off) If the projector gets too hot or emits smoke, shut it down immediately and unplug the power cable. Have your device examined by trained professionals at a tech- nical service location.
ƒ—Focus wheel for image sharpness. Please pay atten- tion to the distance from the projection surface. Mini- mum 0,2m maximum 3m. If the Pocket Projector is located outside of this range, it will not be possible to focus the image. Turn the focus wheel carefully so as to avoid damaging the lens.
2 Turn the device towards an appropriate projection surface or wall at a distance of at least 0,2m and at most 3m. Make sure the projector is in a secure position. 3 Use the focus wheel on the top to adjust the image sharpness.
/ iPhone Cable ...(PPA 1160 / 253372471) Connecting using Video (CVBS) Cable Use the projector's audio/video cable (AV cable) to connect camcorders, DVD players or digital cameras. The jacks for these devices are yellow (video), red (audio right) and white (audio left).
Connecting to a Computer (VGA) Use the VGA audio cable (accessory) to connect the projector to a computer, laptop or some PDAs. The projector supports the following resolutions: VGA/ SVGA/XGA . For best results, set the computer's reso- lution to SVGA (800x600).
5 Video playback 1 Connect the audio/video output of the external device to the A/V or VGA / YPbPr socket of the Pocket Projector. Use the corresponding cable and cable adapter for this purpose. Notice Both jacks occupied If both sockets on the Pocket Projector are occupied, only the signal from the A/V socket will be played.
When operating from the power supply, Power Save is always deactivated in order to ensure the best possible image display. Information Display information of the device Reset settings Reset settings to factory defaults. Philips · PPX1230...
Wipe over the surfaces gently. Be careful that you do not scratch the surfaces. Cleaning the Lens Use a brush or lens cleaning paper for cleaning the lens of the projector. DANGER! Do not use any liquid cleaning agents Do not use any liquid cleaning agents for cleaning the lens, to avoid damaging the coat- ing film on the lens.
• Check if the video output of the external device is switched on. • Please check that the VGA-output of the computer is switched on. • Check if the resolution of the computer is set to 800x600. Philips · PPX1230...
8 Appendix Technical Data Dimensions (L¦×¦H¦×¦W)...100¦×¦32¦×¦100¦mm Dimensions Weight Weight ...0,28¦kg Recommended Ambient...5¦–¦40¦ºC Recommended Ambient Relative Humidity Relative Humidity ...20¦–¦80¦% (non-condensing) Video Standard (CVBS)... PAL, SECAM, NTSC Video Standard (YPbPr)... 480i/p, 576i/p, 720p, 1080i Headphone connection...Stereo - jack plug: 3,5¦mm Audio Output Audio Output...2¦x¦0,3¦W Technology / Optical Display technology ...0,37"...
Page 14
Sagemcom shall not be liable for any damages or prob- lems arising from the use of any options or any consum- able materials other than those designated as original Sagemcom / PHILIPS products or Sagemcom / PHILIPS approved products. Sagemcom shall not be held liable for any damage result-...
Page 16
PHILIPS and the PHILIPS’ Shield Emblem are registered trademarks of Koninklijke Philips Electronics N.V. and are used by Sagemcom under license from Koninklijke Philips Electronics N.V. È 2010 Sagemcom Austria GmbH All rights reserved Sagemcom Documents SAS Documents Business Unit Headquarters : 250, route de l’Empereur...