ATTACHMENTS, OPTIONS
CARRYING OUT CALIBRATION (ADJUSTING 0 POINT) WHEN LOADED
REMARK
Normally, there is no need to carry out calibration when loaded. It is enough to carry out calibration when
empty, so carry out calibration when loaded only if greater accuracy is required.
1. Check that the normal service meter and time are displayed
on the character display.
2. Press the (&) of monitor panel selector switch 1 and display
"LOAD METER".
3. Press the (&) of monitor panel selector switch 1, then press
the (>) or (<) of monitor panel mode selector switch 2 and
select "CALIBRATION".
4. Press the (&) of monitor panel selector switch 1. "EMPTY
BUCKET" is displayed on the bottom line.
HANDLING LOAD METER
0.
6-17