Table of Contents
Advertisement
ATTACHMENTS, OPTIONS
11. Check the display for the selected material on load meter
display (1).
The present selection display is B.
In the remain mode, "REMAINING TARGET" is displayed
on display (2).
12.If B is to remain selected, press the (!) of monitor panel
mode selector switch 1. B is then selected.
If B is to be changed to A, C, D or E, press the (!) of moni-
tor panel mode selector switch 1.
13.This completes the setting of the remain mode.
The character display returns to the normal service meter
and time display.
Once the setting has been made, even if the starting switch
is turned OFF and operations are stopped, the setting is
retained. When operations are started again, there is no
need to carry out the setting again. All further loads will be
subtracted from the total load recorded before operations
were stopped.
HANDLING LOAD METER
6-11
Advertisement
Table of Contents
