Download Print this page
Sealey TA050 Instructions

Sealey TA050 Instructions

Digital tachometer contact/non-contact

Advertisement

Quick Links

thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
electrical shock
instruction
Hazard
manual
1. SaFetY
1.1.
general SaFetY
Warning! Ensure that Health & Safety, local authority and general workshop practice regulations are adhered to when using this
equipment.
Warning! DO NOT aim the laser beam at your or another person's or animal's eye and beware of reflections from mirrors or other shiny
surfaces.
familiarise yourself with the applications, limitations, and potential hazards of the tachometer.
9
Keep the tachometer clean and in good condition.
9
Protect the tachometer from electro-magnetic fields, static electricity and high temperatures.
9
remain vigilant when using the tachometer on, or near, a running engine where there are rotational parts such as belts, pulleys and fans.
9
maintain correct balance and footing. ensure the floor is not slippery and wear non-slip shoes.
9
remove ill fitting clothing. remove ties, watches, rings, and other loose jewellery, and contain and/or tie back long hair.
9
do not wear gloves near rotational parts.
8
do not get the tachometer wet or use in damp or wet locations or areas where there is condensation.
8
do not use the tachometer for any purpose other than for which it is designed.
8
do not allow untrained persons (particularly children) to operate the tachometer.
8
do not operate the tachometer when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
1.2.
laSer SaFetY
the tA050 utilises a class ii laser that emits low levels of visible radiation (i.e. wavelengths between 400 and 700 nanometres)
which are safe for the skin but not inherently safe for the eyes. the class ii emission limit is set at the maximum level for
which eye protection is normally afforded by natural aversion responses to bright light. Accidental eye exposure is therefore normally
safe, although the natural aversion response can be overridden by deliberately staring into the beam, and can also be influenced by
the use of alcohol or drugs.
Warning! do not look or stare into the laser beam as permanent eye damage could result.
do not direct the laser beam at any person's (or animal's) eyes as eye damage could result.
8
do not operate the tachometer when you are tired or under the influence of alcohol, drugs or intoxicating medication.
Be aware that reflections of the laser beam from mirrors or other shiny surfaces can be as hazardous as direct eye exposure.
9
2.
introduction
i
Professional quality laser instrument for fast and accurate measurement of rotational speed with or without contact. Will also measure total
revolutions, frequency, surface speed and distance. ten selectable data set memories each with maximum, minimum, and average or single
value reading as appropriate. supplied with reflective tape, for non-contact measurement, and three heads for contact measurement. Powered
by 9V battery (supplied) and has jack socket for 6V dc supply.
3.
SpeciFication
i
rotational speed - contact: ............................... 2 - 20,000rpm
rotational speed - non-contact: ........................ 2 - 99,999rpm
total revolutions: ..................................................... 1 - 99,999
sampling time: ............................................ 0.5s @ > 120rpm
Accuracy: ..................................................... ±(0.05% + 1 digit)
surface speed: ........................................ m/m, in/m, ft/m, yd/m
distance: ................................................................. m, in, ft, yd
frequency: ........................................................................... Hz
Battery: ...............................................................................PP3
external Power: ............................................................... 6Vdc
laser output: .............<1mW, Wavelength 630-670nm class ll
© Jack sealey limited
instructions for
digital tachometer contact/non-contact
model no:
laser
Avoid eye
contact
ta050
fig.1
Original Language Version
tA050
issue 5 (H,3,4,f) 02/03/18

Advertisement

loading

Summary of Contents for Sealey TA050

  • Page 1 SaFetY the tA050 utilises a class ii laser that emits low levels of visible radiation (i.e. wavelengths between 400 and 700 nanometres) which are safe for the skin but not inherently safe for the eyes. the class ii emission limit is set at the maximum level for which eye protection is normally afforded by natural aversion responses to bright light.
  • Page 2 ‘0’ has been used the system will automatically advance to the next available memory location. When all ten locations are full (0 to 9), new sets of data will begin to overwrite the original readings. © Jack sealey limited Original Language Version...
  • Page 3 BatterY removal - reFer to Section 4 under the Waste Batteries and Accumulators regulations 2009, Jack sealey ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack sealey ltd Batteries Producer registration number (BPrn) is BPrn00705.