Turning On The Appliance; Maintenance - Ruby SDB-SS 2010 Instructions Manual

6. Turning on the appliance

Turn the switch knob to select:
There are two controls device. They are timer and thermostat.
1/ Timer
It works during the mode of cool drying and the mode of warm drying.
2/ Thermostat
During the mode of hot drying, turn the thermostat knob to the max position. Once the
room temperature has reached the desired temperature, turn the thermostat knob slowly
until a faint "Click" is heard and felt. This is the current temperature and the heater will
now maintain this setting. The appliance will automatically maintain the set temperature.
The thermostat will switch the appliance off when the room temperature is above the set
temperature, and switch on if below.

7. Maintenance

To preserve the performances of the apparatus, it is necessary to remove the dust from
the interior of this one while passing the vacuum cleaner on the radiator grille of the
apparatus. It is also necessary to carry out a de-dusting of the outsides parts:
* Control board
* Between the apparatus and the wall
* Underneath and on the apparatus
ENSURE YOU THAT the apparatus is off (button M/A is in position A) then:
To remove dust, use a soft rag.
To remove a spot, humidify the rag slightly
CAUTION:
Never not to use abrassive or corrosive products which would
be likely to deteriorate the apparatus. Never not use cutting,
conducting objects of electricity which would be likely to deteriorate
the apparatus.
OFF
Cool Drying
Warm Drying
Hot Drying
15