Ruby SDB-SS 2010 Instructions Manual page 4

3. Warnings
It is normal for a slight door to be smelt when the appliance is turned on for the fist
time or after cleaning (dust deposited on the appliance).In order to avoid
overheating, do not cover the heater.
Do not swing on the towel rack.(model SDB-SS 2010)
This appliance is designed for wall-mounted installation.
The heater must be installed so that the switch & control can not be touched by
persons in the a bath or shower.
This appliance is designed solely for domestic use. It can not therefore be used for
industrial applications.
This appliance is only designed for drying items washed in water.(model SDB-SS
2010)
Don't insert or allow any other object to enter any ventilation or exhaust opening
because this may cause an electrical shock, fire or damage to the heater.
Don't leave the heater unattended. Always unplug the heater when not in use.
The supply cord must never be pulled over sharp edges or jammed.
Don't cover the heater at any time when operating.
If the appliance is faulty or damaged, it must be repaired by an authorizer service
center.
The appliance must only be cleaned externally by use of a dry or slightly moist
cloth.
Observe your appliance when turning it on for the first time.
Before hanging the towel, please make sure that there is no water drop from the
towel..(model SDB-SS 2010)
The heater must not be located immediately below a socket-outlet
Means for disconnection must be incorporated in the fixed wiring in accordance
with the wiring rules.
It is recommended that installation shall be conducted by quality electrician.
If the supply cord is damaged, it must be replaced by a special cord or assembly
available from the manufacturer or its service agent.
VERY IMPORTANT
•
Never cover
12