Making Connections - Radial Engineering Exo-Pod RAD-EXO-POD User Manual

®

MakING CoNNECTIoNs

The Exo-Pod is a passive device. This means that it does not require any
power to make it work. You simply connect a balanced line level audio
output from a mixing desk or microphone preamp to the XLR-F input
connector and it will automatically distribute the signal to 10 balanced
XLR-M outputs and four mini 3.5mm connections. The XLR outputs are
balanced following the AES standard with pin-1 (ground), pin-2 (+) and
pin-3 (-). The mini 3.5mm is dual mono with the tip and ring sharing the
same signal. Any output may be connected to unbalanced destinations
using a balanced to unbalanced cable. Connected this way will reduce
the output by approximately 6dB.
Each of the outputs is transformer isolated to eliminate ground loops and
noise. These are supplemented with gRoUND LIFT switches on each
output for further noise abatement. Simply connect your line level source
to the input and the output to various video cameras, portable recorders,
tablets or mobile phones.
Radial Engineering Ltd.
Note - Use of a stereo plug
is recommended. Using a
mono mini plug will reduce
the signal level about 20dB.
3
True to the Music
Exo-Pod™ Audio Splitter