Advertisement
Last update: 2016-12-09 22:42
Step 2.
Connect the Zigbee to RS485 converter to the EM24 energy meter:
Zigbee Converter Energy meter
GND
Terminal 43
A
Terminal 42
B
Terminal 41
Step 3.
Make sure only one Zigbee device is powered up right now: the Zigbee to USB converter connected to
the CCGX. Power down all others. If you don't do this, the Zigbee to RS485 converter may be
connected permanently to another Zigbee device.
Step 4.
Connect the 12V DC power supply to the Zigbee to RS485 converter. When the power is switched on,
check the LEDs again.
Option B: Wired connection to CCGX
Connect the Energy Meter to the CCGX using the USB to RS485 cable. The RS485 to USB interface
cable between the CCGX and the Energy Meter can be extended up to 100 meters.
RS485 Converter Energy meter
Yellow
Terminal 41
Orange
Terminal 42
Black
Terminal 43
The red, green and brown wire coming out of the USB to RS485 cable are not used
https://www.victronenergy.com/live/
energy-meter https://www.victronenergy.com/live/energy-meter?rev=1481319737
Printed on 2020-11-11 06:43
Advertisement
