Advertisement
Wireless Area Controller rear panel
Ethernet Port for power in and connection to building LAN for communications.
●
PoE is required to supply power to the device
●
PoE port does not supply power out to other devices
●
RESET Button
●
Resets the Wireless Area Controller, does not impact settings
●
PAIR Button
●
Construction Group
●
Removing devices
●
Reset login UN/PW
●
Factory Defaults
●
PAIR button functionality
Using the PAIR button on the Wireless Area Controller allows you to add or remove devices to the WaveLinx system, reset
building network login information and restore factory defaults.
Enter Construction Group
Leave Construction Group
Remove Devices Default Area
Reset administrator and WiFi
UN/PW
Factory Defaults
PAIR button press
1 press
1 press
(after enter Construction group)
Press and hold for 4 seconds
Press and Hold for 20 seconds
Power cycle WAC
Press and hold for 30 seconds
WaveLinx Wireless Area Controller (WAC)
Device outcome
Dim to 10%
Raise to 75%
Devices in Default Area leave
WaveLinx network
All devices and programming
cleared from WAC
WAC LED feedback
IEEE 802.15.4 LED blinks
IEEE 802.15.4 LED ON
Wi-Fi LED fast blink
All LEDs fast blink for 1 minute
WaveLinx Installation instructions
7
Advertisement
