Functions - D&H SH05A Series Manual

8 8

5.1 Functions

• Operation on all locomotive decoders with standard SUSI interface
• Original vehicle specific steam, diesel and electric locomotive sound projects (no „standard sounds")
• Realistic steam driving noise with wheel synchronous and overlapping exhaust strokes, speed dependent pitch and
independent boiling noise
• Realistic diesel hydraulic driving noise with speed dependent pitch, variable idle speed and independent acceleration
stages, turbocharger and dynamic brake
• Realistic diesel mechanical driving noise with several gears, idle speed, several driving and acceleration stages and
possible shifting noise
• Realistic electrical driving noise with traction motor and traction motor fan as well as upgrade noises (pantograph,
main switch, etc.), switching mechanism noise and dynamic brake
• Bell, horn, whistle, closing doors, etc. (depending on sound project) can be triggered separately at any time
• All sound sequences are freely configurable ("Function Mapping") and can be triggered randomly
• Speaker terminal protected against short circuit and overload
• Low heat generation through the use of the latest technologies
• Reset function
• Updateability of the firmware via SUSI interface using a programmer
• Loadability of sound projects via SUSI interface using a programmer
The update or loading is possible in the installed state of the sound module. The vehicle must be opened and the sound
module connected to the programmer via the SUSI interface. The software, firmware and sound project download can be
obtained from the Internet and is free of charge.
Fahrzeug-/Funktionsdecoder Sound module
from firmware version 1.14 ab Firmware-Version 1.11