Table of Contents
Advertisement
10
10
6.3 Installation
There are three variants for connecting the sound module:
If your locomotive decoder has a SUSI standard socket, you should use the sound module SH05A-2 or SH10A-2. It
1
has the necessary connection cable for this socket. You can easily plug the connection cable of the sound module into
the interface.
2
If your locomotive decoder has SUSI soldering connections, the sound module must be wired individually. You should
use the sound module with the connecting leads for this purpose (SH05A-3 or SH10A-3).
3
The sound module SH05A-0 or SH10A-0 should only be used by experienced model railroaders, because here the
connecting wires have to be soldered directly onto the sound module.
Connect the wires of the sound module according to the following scheme:
black wire ....................... Ground (GND)
grey wire ......................... SUSI data (ZDAT)
blue wire ......................... SUSI clock (ZCLK)
red wire .......................... Supply voltage (ZVS)
brown wires .................... Speaker
The "VS" connection of the sound module must be connected to the "ZVS" connection of the decoder, if the decoder has
one. If not, use the "VS" connection of the decoder.
Fahrzeug-/Funktionsdecoder
Sound module
from firmware version 1.14
ab Firmware-Version 1.11
Advertisement
Table of Contents
