12
12
7
System format SUSI
7.1 Functions
Speed steps ...................................127
Front light/rear light ....................... yes
Additional functions .........................28
Main track programming ............... yes
7.2 Setting options
The properties of the sound module for operation can be changed as often as desired by programming the "Configuration
Variables" (CV) or the parameters (par). Please take the programming informations out of the instructions of your
programming device.
The sound module always occupies the CV ranges 1 and 2, so an additional SUSI module must be set to CV range 3
(CV897/par897 = 3). The SH05A or SH10A sound module can remain connected for this purpose, as it does not react to
readout or programming commands from CV897/par897. This avoids the cumbersome and difficult to understand "CV
banking" procedure (see SUSI specification version 3.10 for more information).
Hint:
If different speed levels are programmed in the locomotive decoder in DCC mode than in the driving unit, malfunctions may
occur. These also affect connected sound modules. Please also note the instructions for your digital system.
Fahrzeug-/Funktionsdecoder
Sound module
from firmware version 1.14
ab Firmware-Version 1.11