Operation - D&H SH05A Series Manual

Fahrzeug-/Funktionsdecoder Sound module

7.4 Operation

Put the locomotive on the programming track and read out the manufacturer identification of the sound module (CV900/
par900). The default value should be 97. Program the desired locomotive address and start running the locomotive
keeping these setup values. After the first check you can vary the CV or parameters of the locomotive according to your
requirements.
In case your programming device indicates "Error", please check again the correct wiring of the locomotive and pay
attention to the notices for connecting the programming track. Never put such a locomotive into operation!
Please take the mapping, which sound flow corresponds to which sound, from the instruction of the particular sound
project. Not all sound flows from 1 to 16 must contain sounds.
Starting delay:
The starting delay from speed level 0 to speed level 1 (CV63/par016) of the locomotive decoder should be set to a suitable
value. Unsuitable values will result in the starting of the locomotive not matching the noise level. The exact value depends
on the individual sound data.
Hint:
The acceleration time (CV03/par011) and the braking time (CV04/par012) of the locomotive decoder should be set to at
least value 8. Times that are set too low will cause some sound sequences to be skipped and cannot be played back! If
necessary the values of CV/par951 and CV/par952 can be increased step by step for fine tuning.
from firmware version 1.14 ab Firmware-Version 1.11
19 19