Power Button - Samsung SR8895 User Manual (XP) User Manual

Operating the cleaner
Using Guard (virtual door) mode
The VIRTUAL GUARD forms an invisible door that the robotic
vacuum cleaner cannot cross until current room is completly
cleaned. The VIRTUAL GUARD opens the invisible door
when cleaning the of room is complete.
1. Select Guard (virtual door) mode using the Mode/

Power button.

- The mode lamp flashes green.
2. Install the VIRTUAL GUARD at the entrance of the
room to be cleaned.
- Install the VIRTUAL GUARD so that the distance
detection sensor can form an invisible barrier that
the robotic vacuum cleaner cannot cross.
• When not using the VIRTUAL GUARD, turn the power off.
(When not using the robotic vacuum cleaner for long
NOTE
periods of time, separate the batteries to avoid discharging
them.)
• If the Mode/Power button does not work, it indicates
that the batteries have worn out. In this case, replace the
batteries. (Specifications: Type D (LR20) alkaline batteries )
• You can additionally purchase a VIRTUAL GUARD from
Samsung Electronics customer care Co., Ltd.
About the IrdA sensor.
●
The infrared signal transmission may
CAUTION
not be smooth in locations exposed to
halogen lamps or in outdoor locations.
●
Robotic vacuum cleaner uses 3 types of
infrared devices and a device may not
work in front of another device with a
higher priority.
●
When controlling the robotic vacuum cleaner with the remote control, the robotic vacuum
cleaner may cross the virtual fence of the VIRTUAL GUARD or run against an obstacle,
because the remote control signal has a higher priority than the VIRTUAL GUARD signal.
●
When using the robotic vacuum cleaner in a small location or at a close distance, it
may malfunction due to interference of the infrared signals.
●
Install the VIRTUAL GUARD away from the charger as auto charging may be
interrupted if the VIRTUAL GUARD is near the charger.
●
If more than one robotic vacuum is used simultaneously, they may malfunction due
to interference of the infrared signals.
26_ Operating the cleaner
Room1
Charger
Distance Detection Sensor
A guard (virtual door) is formed.
✽ Since an invisible barrier is
formed to prevent the robotic
vacuum cleaner from running
against the VIRTUAL GUARD,
installing the VIRTUAL GUARD
within 30cm of the outside walls
is recommended.
[Infrared Signal Priority]
Remote Control Virtual guard
Room 2
Room 3
VIRTUAL GUARD
Charger