Advertisement
Item Description
already listed as a separate item above)
Components and parts containing toner and ink,
including liquids, semi-liquids (gel/paste) and
toner
Components and waste containing asbestos
Components, parts and materials containing
refractory ceramic fibers
Components, parts and materials containing
radioactive substances
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components and
materials requiring selective treatment can be removed.
Tool Description
Screw driver of "+" type
Hexagonal nut screw driver for D-SUB connector
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment
including the required steps to remove the external enclosure:
1.
Remove the hinge assy by press the hook on the rear cover.
2.
Remove the rear cover screws by the screwdriver.
3.
Remove the rear cover from the top side by hand
4.
Disconnect connectors
5.
Tear out all taps and disconnect the connectors by hands
6.
Remove the screws by the screwdriver
7.
Remove the hex screws by the hex screwdriver
8.
Remove the screws by the screwdrive
EL-MF877-00
Template Revision C
Last revalidation date 09-May-2018
Notes
Include the cartridges, print heads, tubes, vent chambers, and
service stations.
HPI instructions for this template are available at
EL-MF877-01
Quantity
of items
included
in
product
0
0
0
0
Tool Size (if
applicable)
Page 2
Advertisement
