Samsung RR61ECMH User Manual page 8

7. Separate the hinge shaft by using hex wrench fi rst.
Unscrew the bolt to remove the hinge riser and
switch the side of the hinge shaft and the hinge
riser.
Hinge shaft
Hinge riser
8mm Bolt
8. Attach the hinge on the bottom left side of the
refrigerator where bolts were previously removed
in step 6.
Screw the bolts that were removed on the bottom
right side of the refrigerator for the future usage.
10mm
9. Remove the screws on the bottom left and right
side of the refrigerator door.
Switch the side of the door stopper from right to
the left. Hinge riser should be switched as well.
10. Remove the wire cover on top of the refrigerator
door to switch the side of the wires.
8_
setting up
DA99-01950A(1.0)-EN.indd Sec4:8 DA99-01950A(1.0)-EN.indd Sec4:8
10mm
Hinge riser Hinge riser
11. Remove the hinge and the grommet from the
refrigerator door.
Detach the right side hinge cover and pull the
wires out of the hinge cover.
Hinge cover
Grommet
Be careful not to damage the electrical
wires when removing the hinge cover.
CAUTION
12. Use wrench to separate the hinge shaft and then
fl ip the hinge and reattach the hinge shaft.
13. Reassemble the hinge on the refrigerator door by
reversing the step 11.
Make sure to use left side hinge cover (which can
be found underneath the removed plastic cover
from step 2) and remove the grommet.
After reassembling the hinge, wire and the hinge
cover, switch the side from right to the left.
Grommet
14. After switching the hinge, close it with the wire
cover on the top of refrigerator door.
"Cover Wire Door R"
can be found in the
packaging
2011.11.23 5:8:43 PM 2011.11.23 5:8:43 PM