Samsung RR61ECMH User Manual page 7

REVERSING THE
REFRIGERATOR DOOR
Before you reverse the refrigerator door,
make sure to unplug the refrigerator.
WARNING
If this operation is performed by After
sales service, it is not covered as the warranty
service.
Required Tools (Not provided)
Phillips Head
Driver (+)
8mm
Socket Wrench
(for hinge shaft)
(for bolts)
1. Remove 2 screws on the top of the refrigerator.
Screw
2. Remove the plastic cover and make sure to
disconnect the wire connected to it.
After removing the plastic cover, check the parts
for reversing the door.
Be careful not to damage the electrical
wires when removing the plastic cover.
CAUTION
DA99-01950A(1.0)-EN.indd Sec4:7 DA99-01950A(1.0)-EN.indd Sec4:7
10mm Socket
Flat Head
Wrench
Driver (-)
(for bolts)
4mm Hex
Spanner Wrench
(for bottom
hinge shaft)
3. Disconnect the wires and then remove 3 bolts.
Make sure your refrigerator is unplugged
before handling electrical wires.
WARNING
4. Remove the door from the lower hinge by carefully
lifting the door straight up.
Refrigerator door is heavy, be careful
not to injure yourself when removing the
CAUTION
refrigerator door.
5. Separate the front leg cover after removing
2 screws.
Screw
6. Unscrew 3 bolts tightening the hinge and also
unscrew 3 bolts on the bottom left side by the front
leg where removed hinge will be attached.
10mm
10mm
_7
setting up
2011.11.23 5:8:42 PM 2011.11.23 5:8:42 PM