IKEA RENLIG DWTI60 Manual page 7

ENGLISH
• To set the water softener. Refer to the
chapter 'Setting the water softener'.
• To deactivate/activate the audible sig-
nals. Refer to the section 'Audible signals'.
• To cancel a washing programme in pro-
gress. Refer to the chapter 'Setting and
starting a washing programme'.
Delay start button
Use the delay start button to delay the start
of the washing programme with an interval
of 3 hours. Refer to the chapter 'Setting and
starting a washing programme'.
Setting mode
The appliance is in setting mode when all
the programme indicator lights are off and
the end indicator light flashes.
The appliance must be in setting mode for
these operations:
– To set a washing programme.
– To set the water softener level.
– To deactivate/activate the audible sig-
nals.
If a programme indicator light is on, cancel
the programme to go back to the setting
mode. Refer to the chapter "Setting and
starting a washing programme".
Programme indicator lights A and B
Apart the selection of the corresponding
washing programme, these lights have an
auxiliary functions:
• The adjustment of the water softener lev-
el.
• Deactivation/activation of the audible
signals.
Audible signals
You can hear an audible signal:
• At the end of the washing programme.
• When the appliance has a malfunction.
The activation of the audible signals is set
at the factory.
Do these steps to deactivate the audible
signals:
1. Switch on the appliance.
2. Make sure that the appliance is in set-
ting mode.
3. Press and hold the programme selec-
tion/cancel button until programme in-
dicator light A flashes and programme
indicator light B comes on.
4. Press the programme selection/cancel
button again.
– Programme indicator light A comes
on.
– Programme indicator light B starts to
flash.
5. Wait until programme indicator light A
goes off.
– Programme indicator light B contin-
ues to flash.
– The end indicator light comes on.
The audible signals are activated.
6. Press the programme selection/cancel
button again.
– The end indicator light goes off.
The audible signals are deactivated.
7. Switch off the appliance to save the op-
eration.
Do these steps to activate the audible sig-
nals:
1. Do the above procedure until the end
indicator light comes on.
7