Table of Contents
Advertisement
K-CTRL
14. APPENDIXES
A. Safety rules for overhead rigging:
•
The unit should be installed out of reach of people and outside areas where
persons may walk by or be seated.
•
Make sure that the installation area can hold a minimum point load of 10 times the
device's weight.
•
In fixed installations, fix the unit with self-locking screws/nuts to the mounting point.
•
When mounting the unit to truss be sure to secure an appropriately rated clamp to
the hanging yoke using a M10 screw fitted through the center hole of the hanging yoke.
•
Always use a certified safety cable that can hold 12 times the weight of the device
when installing the unit. This secondary safety attachment should be installed in a way
that no part of the installation can drop more than 20cm if the main attachment fails.
•
Never stand directly below the device when mounting, removing, or servicing the
fixture. Make sure the area below the installation place is free from unwanted persons
during rigging, de-rigging and servicing.
•
The operator has to make sure that the safety-relating and machine-technical
installations are approved by an expert before using them for the first time. The installations
should be inspected every year by a skilled person to be sure that safety is still granted.
18
Risk of injury: Overhead mounting requires extensive
experience, including among others calculating working
load limits, good knowledge of the installation material
being used, and periodic safety inspection of all installation
material and the unit. If you lack such qualifications, do not
attempt the installation yourself. Improper installation can
result in body injury. Be sure to complete all rigging and
installation procedures before applying power to the unit.
PRELIMINARY
Advertisement
Table of Contents
