Table of Contents
Advertisement
K-CTRL
unit will recall the last chosen mix (even if the unit was switched off in between).
This mode can also be used for remotely controlling the unit if no specific DMX address
is needed and channels 001-003 can serve as a default. To indicate that the unit is
controlled by an external DMX signal, the DMX LED (3) is lit.
9.4 "d" DMX Mode
Press the MODE button (5) until the
display shows "d", indicating operation in
"d" (DMX) mode. Shortly after that, the
display shows the DMX starting address.
You can choose any DMX starting
address by simply using the UP/DOWN
buttons (6/7). The chosen DMX-address
comes effective approximately 3 seconds
later and will show up on the display (2) in
alternation to the "d". This allows control
DMX channel
CH1
CH2
CH3
CH4
Addressing has to be done as follows:
001 first device
005 second device
009 third device
013 fourth device
This setting is stored even if the device is switched off.
9.5 "P" DMX Preset Mode
If you want to run the pre-programmed
patterns and scenes by an external DMX-
controller you can use the DMX Preset
Mode. Press the MODE button (5) until
12
Value Range
000-255
000-255
000-255
000-127
128-227
228-255
(CH 1-4)
(CH 5-8)
(CH 9-12)
(CH 13-16)
of the unit by any external DMX signal
sending on the chosen channel.
In this mode the potentiometer (1) is
disabled.
The unit receives DMX values on a packet
of four channels and mirrors the received
data on the DMX output (13). If a DMX
signal is present the DMX LED (3) will turn
on. The four channels control the unit as
follows:
Function
Out1 level
Out2 level
Out3 level
Master level
Tact (128=slow / 227=max. speed 23 Hz)
Master level full on, Tact off
*factory default*
and so on.
the display shows "P", indicating operation
in "P" (DMX Preset) mode. Set the DMX
starting address by simply using the UP/
DOWN buttons (6/7). The chosen DMX-
PRELIMINARY
Advertisement
Table of Contents
